Node ID for govern
Hi everone.
I've come across a problem concerning connection of my designer node to a govern instance.
In tutorials I've read that it's binding to set up a correct NodeId for an instance to be connected to govern.
But the thing is that I can't find any NodeID in the designer instance (see screenshot).
Also I failed to find proper guidance on this topic.
Would be very glad to receive help.
Thanks.
Operating system used: MacOs 13.1
Answers
-
Alexandru Dataiker, Dataiku DSS Core Designer, Dataiku DSS ML Practitioner, Dataiku DSS Adv Designer, Registered Posts: 1,225 Dataiker
Hi @Mikhivin
,
You've installed DSS on MacOS with the Launcher most likely in this case the node id is not set in install.ini this is done automatically for a Fleet Manager-managed instance or if you pass the argument when installing DSS.~/Library/DataScienceStudio/dss_home/bin/dss stop
Edit the install.ini file If this was not done you can just edit ~/Library/DataScienceStudio/dss_home/install.ini in the general section node-id = some_value.
~/Library/DataScienceStudio/dss_home/bin/dssadmin regenerate-config
Start DSS
~/Library/DataScienceStudio/dss_home/bin/dss start
-
Hi, @AlexT
Thank you for the answer.
I did as you wrote but still has nothing in Govern section,Test Dataiku Govern integration failed:
Dataiku Govern Instance is unreachable
The Dataiku Govern instance is unreachable, please try again later or check your configuration settings
Could you please tell what could be an issue here?
Thank you.
-
Alexandru Dataiker, Dataiku DSS Core Designer, Dataiku DSS ML Practitioner, Dataiku DSS Adv Designer, Registered Posts: 1,225 Dataiker
Hi,
Can you please share a screenshot of your configuration settings?
Also, is the govern node running? Did you install it on MacOS as well? This is an unusual setup for Govern node and likely untested. We recommend setting up DSS/Govern node on Linux VM or CloudStacks.
Thanks -
-
Matias Dataiker, Dataiku DSS Core Designer, Dataiku DSS ML Practitioner, Registered Posts: 12 Dataiker
Hi @Mikhivin
,
Could you please change the value 'nodeid' in the install.ini (Design Node) as attached? It should be 'mydesign'After doing this modification, please proceed on restarting the DSS Service (Design node)
~/Library/DataScienceStudio/dss_home/bin/dss restart
Also just to confirm, did you setup a PostgreSQL db on it? Services of the db and of the govern node are started as well?
If so, please retry the connection and let me know the results.
Just tested from scratch on my environment and the connection seems to be working as attached.
Looking forward to your feedback